Overview

The Fujita Instructions are excellent. Thanks to Fujita for granting permission to post them.

I recommend following the Fujita instructions. Rather than reinventing their instructions, the following is only a brief overview.

Tools needed: phillips screwdriver, flat head screwdriver, ratchet w/ 10mm socket, and an extension.

Step 1

Gently pull the engine cover up.

For the other covers, push the black tabs down in the center to release.

Step 2

Remove the current intake filter housing

Remaining Steps - Follow the Fujita instructions (PDF file)

Remove everything else, swap out the sensor, install the new intake.

Tip- apply a little silicon to the plastic tube that connects to the metal intake. This will help the metal intake slide into the plastic.

Wrap up

If you are a novice, plan on 30 to 45 minutes.

See also - Modz program on 360pump.com